Self-organizing MESH
Multi-hop routing can reconfigure as network topology changes or a node becomes unavailable.
CS7020 Series
Wireless data link · CS7020 series
MESH Broadband Data Link
Software-defined radio architecture with self-organizing MESH networking, factory-configurable frequency options and model-dependent interfaces for UAV and ground-station integration.
33 dBmHighest listed nominal TX rating*
8Node configuration option
IP65Outdoor variant
AES-256Air-interface encryption
Overview
Resilient MESH Connectivity
Multi-hop network architecture, flexible frequency options and application-specific interfaces in the CS7020 family.
Factory-set frequency bands
Center-frequency options include 643, 805, 1350, 1400, 1475, 1685, 2250 and 2450 MHz.
Model-dependent power
Listed model ratings: 27, 30 and 33 dBm nominal. Confirm the measured maximum and factory limit for the selected unit.
Flexible data interfaces
Ethernet, RS232, TTL and SBUS connections vary by model. Refer to the model-specific table below.
Encrypted air interface
AES-256 support for protected data transmission over the wireless link.
Frequency selection
Dynamic spectrum assessment and frequency adjustment within a preset frequency list.
Specifications
Typical Rated Values
Electrical and interface values depend on the selected model. Power ratings below are nominal designations, not a verified absolute output ceiling.
| Model | Nominal TX rating | Supply voltage | Max. power draw | Standby power | Data interfaces |
|---|---|---|---|---|---|
| CS7020-27 | 27 dBm* | 9–30 V | 8 ± 2 W | 4.5 ± 1 W | 1 × LAN; 2 × RS232; 1 × TTL; 1 × SBUS |
| CS7020-30 | 30 dBm* | 20–28 V | 15 ± 5 W | 5 ± 1 W | 2 × LAN; 2 × RS232; 1 × TTL/SBUS |
| CS7020-33 | 33 dBm* | 24–30 V | 20 ± 5 W | 5 ± 1 W | 2 × LAN; 2 × RS232; 1 × TTL; 1 × SBUS |
−40 to +85 °CStorage temperature
−40 to +55 °COperating temperature
5–95%Humidity, non-condensing
Installation & safety notes
- When an antenna port is receiving, the received signal strength must not exceed 10 dBm. Maintain the antenna separation specified for the installation; the source recommends more than 2 m between modules.
- Provide continuous cooling to keep the core at or below 100 °C and the enclosure at or below 80 °C. Never exceed the supply-voltage limit of the selected model.
- Power consumption values are measured at room temperature with a 24 V supply in continuous transmission mode; standby values are measured while connected without active service.
- LAN is 10/100 Mbit/s. RS232 supports up to 115200 baud; 3.3 V TTL supports up to 460800 baud. Where specified, TTL/SBUS is software-configurable.
Configuration
Frequency Bands & Bandwidth
Frequency options are set at the factory. Operation must follow the approved configuration and applicable local spectrum rules.
Factory frequency options
- 643 MHz (608–678 MHz)
- 805 MHz (790–820 MHz)
- 1350 MHz (1300–1400 MHz)
- 1400 MHz (1350–1450 MHz)
- 1475 MHz (1420–1530 MHz)
- 1685 MHz (1660–1710 MHz)
- 2250 MHz (2200–2300 MHz)
- 2450 MHz (2400–2500 MHz)
Link configuration
- Bandwidth choices: 1.25 / 2.5 / 5 / 10 / 20 MHz.
- AES-256 air-interface encryption.
- Dynamic frequency selection within a preset list.
- Available nominal TX designations on this page: 27 / 30 / 33 dBm; measured maxima must be verified.
- Configuration and network topology depend on the selected model and application.
Interfaces
Interfaces & I/O
Connector format and the number of active ports vary by model.
Ethernet
One or two 10/100 Mbit/s LAN connections, depending on model.
Serial & control
Two RS232 connections and TTL / SBUS availability as specified for each version.
Power & RF
Model-dependent power connectors and two 50 Ω antenna ports.
Model-specific interface definitions
| Model | Power interface | Ethernet | Serial / control |
|---|---|---|---|
CS7020-27
|
HX15006-8AWB, DC 24 V (VCC, VCC, GND, GND) | 10/100 Mbit/s LAN (TX+, TX−, RX+, RX−) | HX15006-12AWB: 2 × RS232 (T0/GND/R0, T1/GND/R1); 3.3 V TTL (T2/GND/R2); SBUS (T3/GND/R3) |
CS7020-33
|
XT30PW-M, DC 24 V (GND, VCC) | HX15006-8AWB: LAN1 and LAN2, 10/100 Mbit/s | HX15006-12AWB: 2 × RS232; 3.3 V TTL; SBUS |
CS7020-30-IP65 tail cable
2-core power cable and 8-core composite shielded cable; XT60H-M power interface and RJ45 network port. Source-specified default tail length: 5 m.
RF antenna ports
Standard module: ANT1 and ANT2 use SMA-K connectors. IP65 variant: RF Port 1 and RF Port 2 use N-K connectors.
Status indicators
LED Definitions by Model
The exact layout may differ on customized hardware; refer to the delivered unit.
CS7020-27
Digital interface facing down; indicators are ordered top to bottom.
LED1: Network port status.
LED2: Link established (green); disconnected (red).
LED3: Normal power (steady green).
CS7020-33
Digital interface facing down; indicators are ordered top to bottom.
LED1: LAN1 (red) / LAN2 (green) status.
LED2: Link established (green); disconnected (red).
LED3: Normal power (steady green).
CS7020-30 / IP65 variant
Indicator order is model-dependent; the source describes:
LED1: Power / FPGA download state.
LED2: Signal strength, green → yellow → red → no signal.
LED3: Link establishment.
LED4–5: LAN1 and LAN2 status.
Mechanical
Dimensions & Weight
Reference weights and original model drawings. Dimensions are shown in the drawings.
| Model | Weight with cooling fins | Weight without cooling fins |
|---|---|---|
| CS7020-27 | 0.067 kg | 0.056 kg |
| CS7020-30 | 0.18 kg | 0.11 kg |
| CS7020-33 | 0.16 kg | 0.10 kg |
In the box
Accessory Information
Source-listed cables for the corresponding models; confirm the final package configuration when ordering.
CS7020-27
- 8-core power + network cable · 0.5 m × 1
- 12-core serial cable · 0.5 m × 1
CS7020-30
- XT30 to DC power cable · 0.3 m × 1
- PH2.0-to-RJ45 network cable · 1.5 m × 2
- PH2.0 6-core serial cable · 0.2 m × 1
- PH2.0 3-core serial cable · 0.2 m × 1
CS7020-33
- XT30 to DC power cable · 0.3 m × 1
- 8-core network cable · 0.5 m × 1
- 12-core serial cable · 0.5 m × 1
Ordering guide
Naming Rule & Model Examples
CS7020-30-1400-3J2T-10M-IP65
CS7020 — platform family
30 — nominal TX rating, dBm
1400 — center frequency, MHz
3J2T — 3 nodes, 2 hops
10M — 10 MHz bandwidth (unspecified: standard 20 MHz)
IP65 — outdoor enclosure (unspecified: IP20)
Example MESH configurations
| Network option | Nominal TX rating* | Frequency range | Example model code |
|---|---|---|---|
| 4 nodes / 2 hops | 27 / 30 / 33 dBm | 1350–1450 MHz | CS7020-XX-1400-4J2T |
| 8 nodes / 1 hop | 27 / 30 / 33 dBm | 1420–1530 MHz | CS7020-XX-1475-8J1T |
| 5 MHz option / 4 nodes / 2 hops | 27 / 30 / 33 dBm | 790–820 MHz | CS7020-XX-805-4J2T-5M |
* XX is a model designation, not a verified maximum. Confirm power cap, network configuration, availability and local frequency authorization with CroSkylink before ordering.
Use cases
Typical Deployments
UAV relay networks
Multi-node aerial and ground data links for authorized civil applications.
Utility inspection
Distributed wireless nodes supporting inspection workflows along infrastructure.
Emergency communications
Deployable local connectivity for on-site coordination in challenging environments.
Plan the right CS7020 configuration
Share your frequency, interface, enclosure and deployment requirements with our team to select a suitable, verified configuration.
Contact CroSkylink